Pneumatic & Manual Rotary Table

Pneumatic Rotary Table

The Two-Station Pneumatic Rotary Table, is made to be used on our Evolution Series or PLC controlled thermal assembly units and can significantly reduce cycle times. The table automatically rotates 180 degrees each time the palm buttons are pressed, bringing the opposite nest under the head. Once the thermal head comes down, the operator can release the palm buttons, remove the finished part and load a new part while assembly is taking place. The rotary table can achieve speeds almost equal to 4, 6 or 8 station dial tables, yet with only two nests required, making it more economical to tool.

• Accurate repeatable assembly using a shot pin for positive location
• Adjustable stops
• Flow controls on cylinder
• All adjustments in one location
• Low torque for safety

This rotary table is considered a custom option and should be ordered at the time that you purchase your thermal machine.  The two nests required for assembly are not included but can be quoted separately.  If at a later date your production requirements increase, installation on an existing Evolution Series thermal unit is quick and easy.  Simply bolt it to your machine with the supplied bolts and plug it into the connector on the machine base.  The PLC will recognize the Turn Table and you are ready to go.

• Circular table tops allow mounting of two nest sets for quick tooling changes between similar parts. Unbolt table top, rotate to new nest set, bolt and begin.
• Larger tables customized for large parts.

See a video demo

The Pneumatic Rotary Table automatically rotates 180 degrees each time the palm buttons on the 2020 are pressed. This allows the operator to remove the finished part and load a new one while the thermal assembly is taking place.  (Pictured above is our TBY077 Evolution unit with tooling mounted to the rotary table)

• Pneumatic requirements: Clean, dry air @ 60 psig
• Piston diameter: 21mm
• Weight: 20 lbs.
• Port size: 1/8 NPT

Manual Rotary Table

The Manual Rotary Table, made to fit all of the thermal assembly units is an economical solution to reducing cycle times. The table manually rotates 180 degrees each time the operator rotates the handle, bringing the opposite nest under the head.  Once the thermal head comes down, the operator can release the palm buttons, remove the finished part and load a new part while assembly is taking place.

This rotary table is considered a custom option and should be ordered at the time that you purchase your thermal machine.

• Durable handle
• Heavy-duty bearing construction

Weight: 18 lbs.

Item# TBY107
Two-Station Pneumatic Rotary Table

Item# TBY115
Manual Rotary Table